EWS2 EWS3.2 EMULATOR

EWS2 EWS3.2 EMULATOR support E34 E36 E38 E39 E46 IMMO Immobilizer INSTALLATION: 1. Remove original EWS2 control unit, find + 12v ACC, GND, K-line wires, attach emulator. Emulator must be in service mode: JUMPER 1 shorted. 2. Connect ANY K-line diagnostic adapter to vehicle diagnostic connector and launch EMULATOR CONFIGURATION UTILITY: 3. Choose COM port, write in desired ISN number, press button Store. Or – 4. For some ECU s it is possible to read ISN number directly from engine control unit. In this case select option " ECU xxxxx" , press Read. Software will try to read ISN. If successful, choose option " EWS emulator" and press button Store to save ISN number into emulator. 5. Disconnect emulator from K-line, remove JUMPER 1 and connect K output from emulator to DME( DDE) EWS line. 6. Don' t forget to short two starter relay wires ( EWS connector) ! 7. Car is ready to start. In case of EWS3.2 similar procedure is used, only difference is that that it is NOT connected directly to diagnostic K-line. There are NO any counters or car starts limited. You can change and store new ISN without any limitations. Emulator is shipped with JUMPER 1 shorted. For testing purposes ISN 0579 is stored by default.